MacDon R113 SP, Руководство оператора

Страница: 99 / 240

215009
85
Revision A
3.11.2 Installing Cutterbar Deflectors
The cutterbar deflectors are used with roll conditioners only.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove key, and
engage windrower lift cylinder safety props before going under machine for any reason.
1. Raise the header fully.
2. Shut down the engine, and remove the key from the ignition.
3. Engage the header safety props. For instructions, refer to 3.3 Engaging and Disengaging Header Safety Props, page 24 .
4. Clean debris from ledge and the six mounting holes along aft edge of cutterbar.
1024786
A
B
C
Figure 3.125: Left Side Cutterbar Deflector Viewed
from Underside of Cutterbar
5. Position left deflector (A) on the aft edge of the cutterbar,
and align slots in deflector (A) with the existing fasteners
and cutterbar plug.
6. Install bolt (C) shared with rock guard at outboard end of
deflector.
7. Secure the deflector to the cutterbar with three button
socket head M10 bolts (B) and lock nuts. Bolts are inserted
into the cutterbar from the bottom.
1024788
A
B
C
D
Figure 3.126: Right Side Cutterbar Deflector Viewed
from Underside of Cutterbar
8. Position right deflector (A) on aft edge of cutterbar, and
install three button socket head M10 bolts (B) with lock
nuts. Bolts are inserted into the cutterbar from the bottom.
9. Install bolt (C) shared with rock guard at outboard end of
deflector.
10. Align the right deflectors with the left one at position (D)
and tighten bolts (B) to 54 Nm (40 lbf·ft) with a 17 mm
socket and an 8 mm hex key.
OPERATION