MacDon R113 SP, Руководство оператора

Страница: 87 / 240

215009
73
Revision A
3.10 Conditioner
Rolls condition the crop by crimping and crushing the stem in several places, which allows the release of moisture resulting
in faster drying times. Both steel and polyurethane conditioner rolls are available. Refer to
5 Options and Attachments,
page 197 for ordering information.
3.10.1 Roll Gap
The roll gap controls the degree to which crop is conditioned as it passes through the rolls. Roll gap is factory-set at
approximately 3 mm (1/8 in.) for polyurethane rolls, and at 6 mm (1/4 in.) for steel rolls.
Polyurethane rolls are better suited for crushing stems while providing reduced crimping and are recommended for alfalfa,
clover, legumes, and similar crops. Correct crop conditioning is achieved when 90% of the stems show cracking, but no
more than 5% of the leaves are damaged. Set the roll gap to produce these results.
Steel rolls can be operated over a larger range of roll gap settings (intermesh) and are therefore suited to a wider range of
crops (alfalfa to thicker-stemmed cane-type crops) using a roll gap of up to 25 mm (1 in.); however, too large of a gap may
cause feeding problems.
Grass-type crops may require less gap for proper feeding and conditioning.
IMPORTANT:
If using settings below the factory setting, visually inspect the roll gap.
OPERATION