215794
123
Revision A
1011783
CXXX
EXXX
ACTIVATE DWA DRV
D 0 P 0
- +
D
D
B
A
C
E
Figure 5.146: DWA Drive
7.
Press SELECT (E) until ACTIVATE DWA DRV appears on the
upper line.
8.
Press and hold HAZARD button (C).
•
Press left arrow (B) to decrease the DWA drive speed.
•
Press right arrow (D) to increase the DWA drive speed.
IMPORTANT:
Do
NOT
overspeed the DWA drive.
NOTE:
Ensure that the DWA drive is working properly.
9.
Release HAZARD button (C). The DWA drive will stop.
10. Press PROGRAM (A) to exit programming mode or press
SELECT (E) to proceed to the next header function option.
5.9.9
Testing Reel Fore-Aft Activate Function Using Cab Display Module
The cab display module (CDM) can be used to test the reel fore-aft circuit, rather than using the controls on the operator
’
s
station.
NOTE:
•
The windrower must be attached to a header to perform this procedure. For more information, refer to
Headers to M Series Windrower, page 147
•
The engine must be running to perform this procedure.
DANGER
Ensure that all bystanders have cleared the area.
1011772
C###
E###
WINDROWER SETUP?
NO/YES
A
B
Figure 5.147: CDM Programming Buttons
1.
Start the engine.
2.
Press PROGRAM (A) and SELECT (B) simultaneously on the
CDM to enter programming mode.
•
WINDROWER SETUP? will appear on the upper line.