MacDon M Series, Руководство по сборке

Страница: 59 / 91

UNLOADING AND ASSEMBLY
Form # 169242 Model Year - 2009 57
HYDRAULIC LINK WITH OPTIONAL SELF-
ALIGNMENT KIT
1. Adjust the position of the center link cylinder
with the REEL UP and REEL DOWN
switches, and HEADER TILT switches on
the GSL to position the hook above the
header attachment pin.
2. Lower the center link (G) with the REEL
DOWN switch onto the header pin (H) until it
locks into position (handle is down)
CAUTION
Check to be sure all bystanders have cleared
the area.
e. Start engine.
f. Raise the header fully with the header up switch
on the GSL. Stop engine and remove key.
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header.
g. Engage lift cylinder stops on both lift cylinders.
h. Install pin (A) through each boot and foot and
secure with hairpin.
IMPORTANT
Ensure pin (A) is fully inserted and
hairpin is installed behind bracket on
boot.
i. Remove pin (J) from storage position in linkages
on both sides and insert in hole (K) to engage
float springs. Secure with hairpin.
j. Disengage lift cylinder stops.
CAUTION
Check to be sure all bystanders have cleared
the area.
k. Start engine, and activate header lift cylinder
switch on GSL to lower header fully. Stop
engine and remove key.
(continued next page)
A
K
J
G
H
HEADER TILT UP
HEADER
TILT DOWN
REEL UP REEL DOWN