MacDon HC10, Инструкция по установке, эксплуатации и каталог запасных частей

Страница: 59 / 186

215593
49
Revision A
3.11.3 Checking Roll Timing
For proper conditioning, the bars on one conditioner roll must be centered between the bars on the other roll. The factory
setting should be suitable for most crop conditions.
$
%
Figure 3.71: Conditioner End
–
Right
1. Remove wing nut and washer (A) and remove tool (B) from
panel at right end of conditioner.
$
%
Figure 3.72: Roll Timing Tool
A - Start Position B - Gauge Position
2. From the rear of the conditioner, position the tool at the
center of rolls (A) as shown in illustration at right, and
manually turn the rolls to the limits of tool (B). Rolls will
engage the tool if timing is correct.
3. Manually turn rolls to release tool.
4. If roll timing requires adjusting, refer to 4.9.3 Adjusting Roll
Timing, page 69 .
5. Return the tool the storage location on the right end of the
conditioner. Secure it with a washer and wing nut.
WARNING
Remove the tool from the rolls and return it to the storage
location before starting machine.
3.11.4 Activating the Hay Conditioner - M Series Cab Display Module
The HC10 hay conditioner feature must be activated in the windrower
’
s cab display module (CDM).
NOTE:
•
This procedure is for draper headers only.
1. Turn the ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on the CDM to enter
programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
UNLOADING AND ASSEMBLY