214685
258
Revision A
Figure 7.224: John Deere Combine Display
7.
Select HEADER in box (A) by scrolling down to the box
using the scroll knob, and then pressing the check mark
button (knob and button are shown in Figure
8.
Scroll down to the lower right icon that resembles an
arrow in a diamond (B) and press the check mark
button to select it.
Figure 7.225: John Deere Combine Control
Console
A - Scroll Knob
B - Check Mark Button
9.
Follow the steps listed on the monitor to perform the calibration.
NOTE:
If an error code appears on screen, the sensor is not in the correct working range. Refer to
Range from the Combine Cab (John Deere S and T Series), page 261
to check and adjust the range.
NOTE:
If float was set heavier to complete the AHHC calibration procedure, adjust to recommended operating float
after the calibration is complete.
Содержание FlexDraper FD1 Series
