![background image](http://html2.mh-extra.com/html/macdon/flexdraper-fd1-series/flexdraper-fd1-series_unloading-and-assembly-instructions_3353032195.webp)
214685
183
Revision A
Figure 7.62: Case 8010 Combine Display
8.
Select LEFT SEN (A). The exact voltage is displayed.
Raise and lower the header to see the full range of
voltage readings.
Figure 7.63: Case 8010 Combine Display
9.
If the sensor voltage is not within the low and high
limits, or if the range between the low and high limits is
insufficient, adjust the voltage limits. Refer to
Voltage Limits: One-Sensor System, page 162
Setting Header Controls (Case 8010)
The following procedure applies to Case 8010 combines without a shift button on the control handle.
Figure 7.64: Case Combine Controls
The REEL FORE-AFT switches (A) also control header
fore-aft tilt if header is equipped with the fore-aft tilt option.
The switches can be configured to allow the Operator to
swap between reel fore-aft and header fore-aft tilt.
To set the header controls, follow these steps:
Содержание FlexDraper FD1 Series
