![background image](http://html2.mh-extra.com/html/macdon/flexdraper-fd1-series/flexdraper-fd1-series_unloading-and-assembly-instructions_3353032172.webp)
214685
160
Revision A
Manually Checking Voltage Range: Two-Sensor System
FM100 Float Modules equipped with the optional two-sensor system have a left and right sensor located on the
back frame of the float module.
To manually check the sensor
’
s output voltage range, follow these steps:
1.
Extend guard angle fully; the header angle indicator should be at
D
.
2.
Position the header 150 mm (6 in.) above the ground, and unlock the float.
Figure 7.8: Down Stop Washer
3.
Check that float lock linkage is on down stops
(washer [A] cannot be moved) at both locations.
NOTE:
If the header is not on down stops during the next two
steps, the voltage may go out of range during operation
causing a malfunction of the AHHC system.
Figure 7.9: Float Indicator Box
4.
Adjust cable take-up bracket (B) (if necessary) until
pointer (A) on the float indicator is on
0
.
Содержание FlexDraper FD1 Series
