214323
37
Revision B
Adjusting Endshield
Polyethylene endshields expand or contract when subjected to large temperature changes. The position of the top pin and
the lower catch can be adjusted to compensate for dimensional changes.
1001672
X
Figure 3.16: Left Endshield
1.
Measure gap (X) between the front end of the endshield
and the header frame and compare the measurement to
the values provided in Table
.
Table 3.1 Effects of Ambient Temperature on Endshield Gap
Temperature
°C (°F)
Gap (X) between Endshield
and Frame
mm (in.)
-4 (25)
28 (1-1/8)
7 (45)
24 (1)
18 (65)
20 (13/16)
29 (85)
16 (5/8)
41 (105)
12 (1/2)
52 (125)
8 (5/16)
63 (145)
4 (3/16)
89 (165)
0
If adjustments are required, proceed as follows:
1001364
A
B
C
Figure 3.17: Left Endshield
2.
Open the endshield. For instructions, refer to
.
3.
Loosen nut (A) on pin (B) from inside the endsheet.
4.
Close the endshield and adjust its position to achieve gap
(X) (shown in Figure
) between the front end
of the endshield and the header frame.
5.
Open the endshield and tighten nut (A).
6.
Loosen the bolts on catch (C), and adjust the catch as
needed to reposition the endshield.
7.
Ensure there is a snug fit between the top of the endshield
and the header frame, and that the endshield is fully
engaged on pin (B).
8.
Tighten the bolts on catch (C).
9.
Close the endshield. For instructions, refer to
.
Содержание FD75
