214323
175
Revision B
1003746
A
B
C
D
Figure 4.95: Joystick Buttons
1.
Use button (A) to raise the header or button (B) to lower
the header to the desired cutting height.
2.
Press and hold button (C) for 3 seconds to store the cutting
height in the CLAAS Electronic on-Board Information
System (CEBIS). An alert sounds when the new setting has
been stored.
3.
If desired, program a second set point by using button (A)
to raise the header or button (B) to lower the header to the
desired cutting height. Briefly press button (C) to store the
second set point in the CEBIS. An alert sounds when the
new setting has been stored.
NOTE:
For above-ground cutting, repeat Step
, and use
button (D) instead of button (C) while repeating Step
4.9.5
Setting Sensitivity of Auto Header Height Control
–
CLAAS 500 Series
Setting the sensitivity of the auto header height control (AHHC) system on the CLAAS 500 combine affects how quickly the
AHHC system changes the height of the header.
NOTE:
The upper and lower limits of the header height must be programmed into the CLAAS Electronic on-Board Information
System (CEBIS) before adjusting the sensitivity of the AHHC system. The AHHC sensitivity can be set to a value ranging from
0
–
100%. When the sensitivity is set to 0%, signals from the sensing bands have no effect on the automatic cutting height
adjustment. When the sensitivity is adjusted to 100%, signals from the sensing bands have the maximum effect on the
automatic cutting height adjustment. The recommended starting point is 50%.
NOTE:
Changes may have been made to the combine controls or the display since this document was published. Refer to the
combine operator
’
s manual for updated information.
1010068
C
D
A
B
E
Figure 4.96: CLAAS Combine Controls
1.
Use < key (C) or > key (D) to select SENSITIVITY CAC. Press
OK key (E).
2.
Use
–
key (A) or + (B) key to change the reaction speed
setting. Press OK key (E).
Содержание FD75
