![background image](http://html.mh-extra.com/html/macdon/dwa/dwa_setup-operation-and-parts-manual_685683030.webp)
215626
20
Revision A
$
%
&
Figure 2.18: Front Engine Mounts
3.
Remove outer bolt and nut (A) from front engine
mounts (B) on the left and right sides of engine (C). Retain
the nuts.
$
%
%
&
&
' (
)
Figure 2.19: Linkage Support Installed
4.
Mount linkage support (A) to the windrower frame with
two 1/2 in. x 2 3/4 in. long hex head bolts (B) with flat
washers under the bolt heads. Secure the bolts with
nuts (C).
NOTE:
These bolts replace the engine mount bolts removed in
Step
5.
From below the support, install 3/4 in. x 3 1/2 in. long hex
head bolt (D) with flat washer (E) under the bolt head.
6.
Secure the bolt with a flat washer, a lock washer, and a nut
on the top side of the frame.
7.
From above the support, install 3/4 in. x 5 1/2 in. long hex
head bolt (F) with a flat washer under the bolt head.
Do
NOT
install a nut on bolt (F).
$
%
Figure 2.20: DWA Linkage
8.
Support linkage assembly (A) with a forklift.
IMPORTANT:
Make sure forks (B) of the forklift do not lift against the
cylinder fitting.
Содержание DWA
