169784
57
Revision H
1011884
A
B
C
Figure 3.92: Right Endsheet
2.
Line up the pilot hole drilling template as shown at right.
a.
The bottom right hole in the template should line up
with the hole where the wiring harness clip bolt was
located (A).
b.
The upper left hole in the template should line up with
the existing hole (B) on the fore side of the clip
bolt hole.
c.
Fasten the template to the endsheet with the bolt
hardware provided in the kit.
3.
Drill two 3.2 mm (1/8 in.) pilot holes at location (C),
through the template into the endsheet frame.
4.
Remove the template.
5.
Drill two 10.3 mm (13/32 in.) holes into the frame endsheet
where the pilot holes were made.
1011883
A
Figure 3.93: Bracket (MD #279065)
6.
Install the hitch support bracket (A) (MD #279065) on the
endsheet with two 3/8 NC x 3/4 in. carriage bolts and
flanged smooth faced nuts.
Содержание D65
