MacDon 912, Руководство оператора

Страница: 76 / 84

Form # 46620 Issue 11/06
74
ATTACH FORMING SHIELDS - OPTIONAL
(HIGH) POSITION WITH XX52(i) TRACTOR
L
L
UNLOADING & ASSEMBLY
ATTACH HAY CONDITIONER FORMING SHIELDS
NOTE: If attaching header to a Bi-Directional
Tractor, see 802 Adapter Operator's Manual for
instructions.
Standard (Low) Position
Attach hay conditioner forming shields to
conditioner top cover:
1. Remove nuts (E) and front hinge support (F) at
rear of hay conditioner, both sides.
2. Attach forming shield by positioning rubber
hinges (G) on bolts at rear of hay conditioner,
and reassembling support (F) and nuts (E) as
shown.
3. Attach rear supports to forming shield
assembly, at the second bolt (P) from each
end as shown.
4. Attach top bracket of rear support to front hole
(H) in tractor floorboard, each side.
NOTE: If mounting to a XX52/XX52i tractor
with the angle reduction kit, attach top bracket
of rear support to large holes (J) & (M) in
floorboards. Install hex head bolt (provided)
from top of floor board with the one washer
under bolt head to keep bolt from pulling
through large hole (J) & (M).
Optional (High) Position
Attach hay conditioner forming shields to tractor
frame. This may be preferred if header is
frequently removed from tractor:
1. Attach side supports (N) (available from your
Dealer) to forming shield assembly as shown
in above illustration.
2. Mount forming shield assembly on top rear pin
of tractor lift linkage, both sides. Secure with
hair pin.
3. Attach rear supports to forming shield
assembly, at the second bolt (P) from each
end as shown in above illustration.
4. Attach top bracket of rear support to rear hole
(K) in tractor floorboard, each side. See above
illustration.
NOTE: If mounting to a XX52/XX52i tractor
with the angle reduction kit, attach top bracket
of rear support to large holes (J) & (M) in
floorboards. Use one washer on each side of
the floorboard to keep bolt and nut from pulling
through large hole (J) & (M).
NOTE: For high clearance tractors (MacDon
9352/9352i, Westward 9352/9352i, Prairie Star
4952/4952i, Premier 2952/2952i), reposition side
support brackets to extended position (L) as
shown below.
N
ATTACH FORMING SHIELDS -
OPTIONAL (HIGH) POSITION
WITH XX40/XX50 MODEL TRACTORS
ATTACH FORMING SHEILDS
STANDARD (LOW) POSITION