MacAllister MGTP254, Руководство оператора

Страница: 12 / 20

The machine is supplied with
some of the components disassembled and the
fuel tank empty.
Mount the components
very carefully so as not to impair the safety
and efficiency of the machine. If in doubt, con-
tact your dealer.
Unpacking and complet-
ing the assembly should be done on a flat and
stable surface, with enough space for moving
the machine and its packaging, always making
use of suitable equipment.
Disposal of the packaging should be done in ac-
cordance with the local regulations in force.
1. MOUNTING THE FRONT HANDGRIP (Fig. 1)
The purpose of the spacer
(1) is to ensure a minimum distance between
the rear handgrip and the front one, for safety
reasons. This spacer must always be fitted
and must not be modified in any way.
– In front of the spacer (1), position the upper part
(2) of the front handgrip.
– Fasten the lower cap (4) to the upper part (2) with
screws (5).
– Before tightening the screws (4), align the hand-
grip correctly with respect to the drive tube.
– Fully tighten the screws (4).
2. MOUNTING THE ROD
(Models with separate rod – Fig. 2)
– Pull out the stop pin (5) and push the lower part
of the rod (4) right down until the stop pin (5) slots
into the hole (6) in the rod. This is easier to do if
you rotate the bottom of the rod (4) slightly in
both directions. The pin (5) is in place when it is
completely lodged in the hole.
– Lastly, tighten the knob (7) securely.
WARNING!
WARNING!
WARNING!
IMPORTANT
3. MOUNTING THE GUARD (Fig. 3)
The protection must be
suitable for the machine model and the type of
cutting tool used, and fitted correctly to re-
spect the correct position of the line cutting
knife.
– Lined up with the lock (1), position the guard (2)
and fasten it with the cap (3) and the screws (4).
4. REMOVING AND REFITTING
THE CUTTING LINE HEAD (Fig. 4)
– Block rotation of the shaft (2) with the proper
key.
– Remove the cutting line head (1) unscrewing it in
an anticlockwise direction .
When mounting,
– Fit the cutting line head (1) screwing it up
in a
clockwise direction .
WARNING!
6 MACHINE ASSEMBLY
EN
4. MACHINE ASSEMBLY