Macab DCB-101, Руководство пользователя

Страница: 28 / 32

28
USER MANUAL DCB-101
SECTION 10
ERROR
Er00
Er01, Er02
Er03
Er04
Er05
Er06
Er07
Er08
Er09
Er10
Er11, Er12
Er13
Er14
Pb01
Pb02
Pb03
Pb04
PbF9
CAUSE
The software that was available for upgrading was of an
older or of the same version as the one already in the
digital-box.
The upgrade failed. Some information was missed out.
The internal memory is not large enough to receive the
upgrade.
The signal was disturbed during the upgrade.
Wrong type of data was received during upgrade.
Not used.
Access problem in back-up memory (EEPROM).
Access problem in video memory.
Can not find any data to do an upgrade.
Poor or no cable-TV signal.
Not used.
Unauthorised data signals received by the digital-box.
Faulty data signals received by the digital-box.
A problem in the ROM memory is detected.
Memory size is too small.
A problem occurred during start up (initialisation
problem).
Internal communication failure.
Hardware error identified during start-up.
MEASURE
Press the
OK
-button on the front panel, alternatively unplug the
mains connector for 10 seconds.
Press the
OK
-button on the front panel, alternatively unplug the
mains connector for 10 seconds. If you have requested an upgrade,
repeat the request.
Press the
OK
-button on the front panel, alternatively unplug the
mains connector for 10 seconds. If you have requested an upgrade,
repeat the request.
Press the
OK
-button on the front panel, alternatively unplug the
mains connector for 10 seconds. If you have requested an upgrade,
repeat the request.
Press the
OK
-button on the front panel, alternatively unplug the
mains connector for 10 seconds. If you have requested an upgrade,
repeat the request.
Press the
OK
-button on the front panel, alternatively unplug the
mains connector for 10 seconds. If you have requested an upgrade,
repeat the request. If the problem persists, contact your retailer.
Press the
OK
-button on the front panel, alternatively unplug the
mains connector for 10 seconds. If you have requested an upgrade,
repeat the request. If the problem persists, contact your retailer.
Press the
OK
-button on the front panel, alternatively unplug the
mains connector for 10 seconds. If you have requested an upgrade,
repeat the request.
Inspect all connections. If the problem persists, contact your cable-
TV-operator.
If the error message persists, contact your cable-TV-operator.
If the error message persists, contact your cable-TV-operator.
Contact your retailer. The digital-box is damaged.
Press the
OK
-button on the front panel, alternatively unplug the
mains connector for 10 seconds. Try to upgrade again by turning
the digital-box off and on again.
Press the
OK
-button on the front panel, alternatively unplug the
mains connector for 10 seconds. If the problem persists, contact
your retailer.
Press the
OK
-button on the front panel, alternatively unplug the
mains connector for 10 seconds. If the problem persists, contact
your retailer.
Press the
OK
-button on the front panel. Alternatively unplug the
mains connector for 10 seconds and then re-start the digital-box.
If the problem persists, contact your retailer.
Tracing a problem
OK-button
RESET THE DIGITAL-BOX
If an error occurs that can not be cured according to description on this
page, the final measure is to make a complete reset by unplugging the
mains-lead and re insert it again after approximately 10 seconds.