MAC TOOLS MTPROA, Руководство по эксплуатации и обслуживанию

Страница: 8 / 28

MACTOOLS.COM
8
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
The jump starter won’t jump start my car. Clamps are not making a good
connection to the battery.
Connections are reversed.
The jump starter’s battery is not
charged.
The vehicle’s battery is defective.
The fuse has opened.
Check for poor connection to battery
and frame. Make sure connection points
are clean.
Disconnect the jump starter and reverse
the clamps. The fuse will need to be
replaced.
Press the Battery Status button
on the front of the unit. The LEDs will
indicate the status of charge.
Have the battery checked.
Replace the fuse.
The jump starter won’t power my 12V
device. The 12V device is not turned on.
The jump starter’s battery is not
charged.
The 12V device draws more than 15A
or has a short circuit.
Turn on the 12V device.
Check the battery charge status by
pressing the Battery Status button.
Disconnect the 12V device. The internal
breaker will automatically reset after a
minute or two. Try the 12V device again.
The battery in the jump starter won’t
hold a charge. The battery is bad
(will not accept a charge). Replace the battery.
ACCESSORY/REPLACEMENT PARTS
PART # DESCRIPTION REPAIR LOCATION
MTPROA-F FUSE REPLACEMENT KIT User
MTPROA-FC FUSE COVER REPLACEMENT Repair center
MTPROA-RC RED (POSITIVE) REPLACEMENT CLAMP Repair center
MTPROA-BC BLACK (NEGATIVE) REPLACEMENT CLAMP Repair center
MTPROA-B BATTERY REPLACEMENT KIT Repair center
MTPROA-DC 12V DC PORT REPLACEMENT KIT Repair center
MTPROA-CBS BATTERY CABLE REPLACEMENT KIT Repair center
MTPROA-PC POWER CORD REPLACEMENT User
MTPROA-2MC MALE-TO-MALE VEHICLE CIGARETTE LIGHTER ADAPTER User