42
43
MLMP475iSSP46-M&S-2
MLMP475iSSP46-M&S-2
In
more
detail
. . .
In
more
detail
. . .
NOTE:
Replace the cutting means (29) after
50
hours of mowing, or
2
years
whichever is sooner regardless of condition. If the cutting means (29) is
cracked or damaged, replace it immediately.
7. Lubricate the cutting means (29) after each use to prolong their life span. Apply
lubrication oil/grease along the edges of the cutting means (29).
29a
29b
29
29d
29e
29c
Torque wrench
(40 - 45 Nm)
30
Underbody and cutting means cleaning
NOTE:
Do not use pressure washer for cleaning. It may force water to enter
the vital areas of the product.
1. Set the cutting height to the lowest position using the lever (22).
2. Connect a water hose with a quick connector to the water hose connector (14)
(Fig. 31). Turn on the water supply.
NOTE:
A quick connector must be used to connect the water hose and the
connector (14).
Underbody and cutting means
WARNING!
Wear protective gloves when working on the cutting means
(29) and close to it! Use proper tools to remove debris, e.g. a wooden stick!
Never use your bare hands!
Always use original spare parts for replacement. The cutting means must
be replaced by an identical type with the reference number DAYE 2105200263.
Do not attach any other type of cutting means (29)!
The replacement of the cutting means (29) should be done by an experienced
operator! Rework or sharpening blades is not recommended unless it is done
NOTE:
We strongly recommend jacking the product when performing
inspection and work on the cutting means (29). Avoid tilting the product in
order to prevent fuel and oil leakages.
1. Keep the underbody and cutting means (29) clean and free of debris. Remove
clippings from the rear discharge chute (30).
2. Check all nuts and bolts periodically for tightness before the operation. After
prolonged use, especially in sandy soil conditions, the cutting means (29) will
reduced, and the cutting means (29) should be replaced.
3. Keep the cutting means (29) sharp to ensure a good cutting performance. Replace
a worn or damaged cutting means with a new one of the same type or have it
4. If jacking the product is not possible, tilt it to the right side so that the fuel tank
cap (12) side is up. This helps to prevent fuel leakage and harder starting due to
5. Loosen the hex bolt (29e) anti-clockwise and remove it together with the
29d), washer (29c) cutting means (29), and ring (29b) (Fig. 30).
6. Replace the cutting means (29) with a new one of the same type. Slide the ring
(29b) into the slot on the spindle (29a
29),
29d) and hex bolt (29e). Tighten the hex bolt clockwise
with 40-45 Nm force to ensure safe operation of the product (Fig. 30).
DANGER!
If the cutting means (
29
) are not torqued properly, they could
become loose and be thrown from the product and seriously hurt or kill the
operator or bystanders.
Care and maintenance
Care and maintenance
