Mac allister MJ10250XI, Инструкции по безопасности и эксплуатации

Страница: 10 / 29

10
Warning: Before using your table saw,
read the instruction manual carefully.
Warning: Carefully remove the table
saw from the carton and remove the
protective polyfoam from around the
motor.
Warning: Do not connect to the power
supply before assembly, adjustment
and maintenance.
ASSEMBLY OF THE TABLE SAW
1. To assemble the leg stand (Fig. 1-5)
- Unpack all parts, and group them by type and
size. Refer to Fig. 1 for correct quantities.
- Attach one long top leg bracket (1) to the top of
one leg (2) using a screw, flat washer, spring
washer and hex nut. (Fig. 2)
NOTE: Do not tighten the bolts until the stand is
properly aligned (see step #8).
- Attach other end of the long top leg bracket (1)
to top of another leg (2) using using a screw,
flat washer, spring washer and hex nut.
- Attach one long bottom leg bracket (3) to the
centre of each leg (2) using a screw, flat washer,
spring washer and hex nut. This completes the
front frame section. (Fig. 3)
- Assemble the rear frame section in exactly the
same manner.
- Join the front and rear frame assemblies to the
two short upper supports (4) and two short
bottom supports (5) using a screw, flat washer,
spring washer and hex nut. (Fig. 4)
Fig. 1
Stand legs (4pcs)
long top leg brackets (2pcs)
Short top leg brackets (2pcs)
Short bottom leg brackets (2pcs)
Long bottom leg brackets (2pcs)
Rubber feet (4pcs)
Screws M6 x 12 with nuts M6,
flat washers 6 and spring
washers 6 (16pcs)
Fig. 2
Fig. 3 Fig. 4
1
2
1
2
3
2
3
4
2
5
2
3
3
2
2
5
1
4
1