Mac allister 295442024/MCA, Оригинальное руководство пользователя

Страница: 13 / 24

Lawn care recommendations
Each type of grass has different characteristics and may thus require different ways of caring
for the lawn; always read the instructions on seed boxes for mowing height for the growing
conditions in the work area.
Keep in mind that most grass is made up of a stem and one or more leaves. If leaves are fully
cut, the lawn is damaged and growth is more difficult.
The following indications generally apply:
– cutting too low tears and uproots the grass, giving it a “spotted” appearance;
– in the summer, cutting must be higher to prevent the ground from drying;
– do not cut wet grass; this could reduce blade efficiency due to sticky grass and tear the
lawn.
– for particularly high grass, initially mow at the maximum height allowed by the machine then
mow again after two or three days.
The appearance of the lawn will improve if you alternate cutting in both directions at the same
height.
Grass cutting
[3] Preparation for mowing and mulching (if provided)
Lift the rear discharge guard (1) and fit the deflector cap (5) in the outlet, keeping it slightly
tilted to the right. Fasten it by fitting the two pins (6) into the holes provided until the fas-
tener tooth (7) clicks into place.
To remove the deflector cap (5), lift the rear discharge guard (1) and push in the middle to
release the tooth (7).
[4] Starting the engine
For start up, follow the instructions in the engine manual, then pull the blade brake lever
(1) against the handle and firmly pull the knob on the starter cable (2).
[5] For mulching or rear grass discharge
Always avoid removing a large quantity of grass. Never cut more than one third of the
total grass height in a single passage! Regulate the forward speed according to the lawn
conditions and the amount of grass removed.
[6] When work is finished
When work has been completed, release the brake lever (1) and disconnect the spark
plug cap (2).
On models where it is provided, remove the starter key.
WAIT UNTIL THE BLADE STOPS before making any adjustments to the lawnmower.
In
mor
e
detail
...
13
GB
IE
MPRM 42SP / 46SP by MacAllister