10
This tool can also be used in stationary mode.
Place the tool onto the workbench.
Secure the cable to prevent pulling the tool off the workbench.
Carefully switch the tool on.
Make sure that the nozzle always points away from you and any bystanders.
Make sure not to drop anything into the nozzle.
8.7
cooling down
The nozzle and accessory become very hot during use. Let them cool down before attempting to
move or store the tool.
To reduce the cooling time, switch the tool to position I which is at the lowest air temperature
and adjust the air flow to Max. and let it run for a few minutes.
Switch the tool off and let it cool down for at least 30 minutes before storage.
9
MAINTENANCE AND CLEANING
Attention! Before performing any work on the equipment, pull the power plug.
9.1
Maintenance
Your Power Tool has been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper tool care and regular
cleaning.
9.2
Lubrication
Your power tool requires no additional lubrication.
9.3
Cleaning
Keep the ventilation slots clear and regularly clean the housing with a soft cloth.
9.4
Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth, preferably after each use.
Keep the ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents
may damage the plastic parts.
10 TECHNICAL DATA
Voltage
220-240 V ~ 50HZ
Power supply
2000 W
Air temperature / Flow
I 50
℃；
250-500L/min
II 50-650
℃；
250-500L/min
