If any abnormalty occurs during use, please check and correct the following:
Condition
Correction
Display is blank when power is on.
Check and correct the polarity of the
installed batteries. Reinstall or replace
batteries.
Measurement incomplete or
Review and follow “Applying Your
abnormally low or high values
Blood Pressure Cuff” and “Taking
displayed.
Your Blood Pressure Reading” sections.
Replace the batteries.
EE symbol displays.
Do not talk or move during the
measurement. Review “Applying Your
Blood Pressure Cuff” section.
Measurements are different from
Remember, blood pressure readings
Recalling Measurements in Memory
– 15 –
– 14 –
Recalling Measurements in Memory
You can recall up to 60 total measurements in memory. These meas-
urements can be shared with your physician or trained healthcare pro-
fessional.
1. Press and release the MEMORY button. It will show how many
measurements are stored within the bank, followed by the last
result,
Fig. 1
.
2. Press the MEMORY button again to scroll through the saved
measurements. After youʼve scrolled through all the readings, the
unit will automatically turn off.
NOTE:
When the number of readings exceeds 60, the oldest data will
be replaced with the new record.
To erase all stored measurements:
1. Press and release the MEMORY button. The unit will display how
many measurements are stored within the bank.
2. Press and hold down the MEMORY button until two horizontal lines
flash. This indicates that all measurements have been erased,
Fig. 2
.
Description of Display Symbols
Fig. 1
Fig. 2
Indicates a measurement
Indicates a measurement
within Stage 2 Hypertension.
Indicates a measurement
Appears when batteries should be
replaced.
Shows the pulse rate per minute.
Occurs when an error was made
during measurement.
Appears when there is an irregular
heartbeat detected during
measurement.
Appears when the unit is ready or a
measurement error has occurred.
Restart the measurement if an error
occurs.
Appears when the cuff is unstable or it
has too much air left in it. Once the
arrow stops flashing, the unit is ready
to take a measurement.
Appears when recalling a
measurement from memory.
DIA
SYS
DIA
SYS
DIA
SYS
Description of Display Symbols
Troubleshooting
