5
• Plug the dispenser into the electrical outlet. We are ready to com-
plete the first cycle. In order to do that, wait for the hot water to
reach temperature in approximately 10 minutes, and then wait for
the cold to reach temperature (another 40 minutes, approximately).
• Unplug the dispenser from the electrical outlet. Proceed to drain
the water from the faucets one at a time until no more water
remains. (Note: To facilitate this operation, use a large container).
• Then, drain any water left in the tanks by opening the drain plug
located on the back, until it drains completely.
• Proceed to close the drain cap.
• Remove the cap from the 5-gallon bottle and use a clean cloth to
wipe off the neck of the bottle.
• Place the 5-gallon bottle of water on the water intake, allow water
to stand for approximately one minute.
• Push water faucet buttons to insure water flows from both faucets.
• Plug dispenser back into the electrical outlet.
• Now you are ready to use your water dispenser.
NOTE: Your water dispenser has been cleaned and sanitized
before leaving the factory, but in case a taste problem develops,
place two tablespoons of baking soda and add tap water. Fill water
tank again and repeat basic operations previously outlined, except
turn hot water function “OFF” to operation previously outlined,
except turn hot water function “OFF” to avoid leaving residues in
hot water tank.
attention:
If you do not plan to use the water heating function for more
than three days, we recommend that you turn off the hot water
function.
operating your water dispenser
steps to replace water bottles
• Remove cap.
• Use a clean cloth to wipe off neck of bottle.
• Carefully lift bottle (approx. 40 lbs.) using your legs and not your
back. Do not place hands on opening of bottle while placing in
reservoir.
• Insert the water bottle on the water intake over reservoir opening
so it settles properly on it.
• Wipe off any water which may have splashed on dispenser top.
• When a new bottle is installed you must open the hot water faucet
and remove no less than 4 full cups of water to insure the water
flows properly and the water reservoir is at the proper level.
