RE S T RICT IN G O P E RA T IO N
The control can be restricted to prevent unwanted use or temperature adjustments.
From the main screen, activate temperature flashing. While temperature is flashing, press “Light” repeatedly until “LOCK” appears on the screen.
Pressing the temperature up button allows you to toggle through “TEMP”, “OFF” and “ON”.
“TEMP”
allows you to lock the temp./settings.
“ON”
allows you to lock all settings/functions.
“OFF”
does not lock the spa.
UN LO CK IN G
This Unlock sequence may be used from any screen that may be displayed on a restricted panel.While pressing and holding the Temperature Up
button, slowly press the Light button twice. “UNLK” will display on the screen and after a few seconds, will revert to main screen.
A DJ US T IN G F ILT RA T IO N
Main Filtration
Filter cycles are set using a start time and a duration. Start time is indicated by an “A” or “P” in the bottom right corner of the display.
Duration has no “A” or “P” indication. Each setting can be adjusted in 15-minute increments. The panel calculates the end time and
displays it automatically.
To enter filter cycles, activate temperature flashing and press the “Light” button repeatedly until the display reads “FLTR” (with a 1 in
the bottom right corner). Pressing the Light button will bring you to the display “BEGN”. The numbers flashing indicate numbers that
can be changed. Scroll through with the up and down temperature buttons to choose what time your filter cycle will start and press
the Light button to make your choice. “RUN” “HRS” will be on the display next. Again, scroll through the numbers to choose the
duration of your filter cycle.
Filter Cycle 2 - Optional Filtration
Follow the same procedures under “FLTR” (with a 2 in the bottom right corner) to set up filter cycle 2.
It is possible to overlap Filter Cycle 1 and Filter Cycle 2, which will shorten overall filtration by the overlap amount.
Purge Cycles
In order to maintain sanitary conditions, secondary Pumps and/or a Blower will purge water from their respective plumbing by running briefly at the
beginning of each filter cycle.
If Filter Cycle 1 is set for 24 hours, enabling Filter Cycle 2 will initiate a purge when Filter Cycle 2 is programmed to begin.
Содержание TP600
Страница 6: ......
