MAAX Coleman Spas 100 Series, Руководство пользователя

Страница: 9 / 36

09
Jets and air controls
Jets and air controls
Jets
All the jets are designed so that each of them
provides a unique hydro-massage. All the large
jets are adjustable, from a fully open to a fully
closed position.
NEVER CLOSE ALL THE
LARGE JETS AT THE SAME TIME!
Cleaning or replacing the jets
Hard water can cause the accumulation of
limescale or minerals, which can constrict or
block the jets. Each jet consists of a backplate
and a spout. Rotate these components weekly
and remove/clean them monthly so that they
continue to move properly.
N OT E :
If you want to clean or replace a jet, you do
not need to empty the water out of the spa.
Turning the flange and the spout opening
of the jet
• Turn the flange of the jet left and right
(open and closed).
• Turn the flange again fully open.
• Turn the jets on at high speed.
• Turn the spout opening left and right.
• Turn the spout opening in the tube.
N OT E :
If the inserted piece of the jet comes loose
from the spa housing, follow the procedure
below to re-install the jet.
Cleaning the jest
To remove the inserted piece, use the palm
of your hand to apply pressure to the flange
of the jet. Turn anti-clockwise until you hear
a click. Remove the jet component carefully
from the housing.
To clean the installed piece and the housing, use
a spray-gun or garden hose and spray the inside
of the jet. Leave the jet to soak in a dilute spa
cleaning solution and then rinse it off. Brush
the inside of the housing and remove any dirt.
To replace the jet, place the jet components
into the housing. Press the flange down with the
palm of your hand while turning it clockwise
until the spout opening ‘clicks’ back into place.
Air Controls
The force of the water jets can be controlled by
adjusting the amount of air which is injected into
the water before it passes through the jets. There
are two to four air controls on the edge of the
spa. Each Air Control directs air to the relevant
jet in the spa allowing you to set different
combinations and levels of jet action according
to your wishes or preferences.
Turn the Air Control anti-clockwise to close the
air intake, and clockwise to open the air intake.
N OT E :
For optimum energy consumption, the
Air Controls must stay closed when heating
the water.
If your spa is fitted with a Turbo Blower,
at least one Air Control must always
stay open.