MA DRONE 3, Быстрый старт

Страница: 12 / 24

12
hOw thE CONtROlS wORk
follow the radio calibration procedure as described in mission planner.
All other stages of the setup have been done for you. You are now ready to fly your
own hoverbike Drone.
unplug uSb cable from both the pixhawk and the pC.
ChARgiNg bAttERiES
batteries must be charged before use. the batteries are constructed from 6 lithium
polymer cells giving 22.2 volts and 25.2 volts when fully charged without a load. the
capacity of each battery supplied with the hoverbike Drone is 3000 mAh. if available,
it is recommended to set the charge current to 3 Amps and never to charge at over 15
Amps. we recommend charging with the balance leads connected.
When flying from two or more batteries in parallel, you need to ensure that the bat-
teries have the same voltage (voltage per number of cells), energy capacity (mAh) and
power capacity (C rating). Always check that the pack voltage is the same as the others
(+/- 200mv).
it is always best practice to label your batteries as a pair and to charge them both fully
before flight.
Do not drain more than 80% of the batteries capacity.
mODE 2
left stick:
- throttle
- yaw
Right stick:
- pitch
- roll
Contents
System overview 4
in the box 5
Caring for Drone 6
you + Drone 7
Safety first 8
first time setup 9
batteries 12
Controls 12
warning signals 14
First flight 15
Every flight 17
flying modes 19
About Drone 20