MA DRONE 3, Быстрый старт

Страница: 10 / 24

10
Caution: ensure your throttle stick and throttle trim is all
the way down on your transmitter with the other sticks
centered.
The receiver remembers these stick positions and if the re-
ceiver loses signal from your transmitter it will send these stick positions
to the Pixhawk. The throttle trim needs to be lower than usual minimum
throttle to tell the Pixhawk to go into failsafe mode.
whilst holding the bind/switch button, power on your
transmitter (see your radio transmitter manual for
details). Continue to hold the bind switch/button, the red
light on the receiver should go solid after a few seconds.
the receiver light muSt go solid for the bind process to
be successful.
Optional:
using a Spektrum remote (satellite) receiver
you can now release the bind button on your transmitter.
unplug the bind plug from the receiver and plug the sig-
nal cable back in the bind/Sbus port. the bind process is
finished.
Put the bind plug somewhere safe for if you need to bind a different transmitter to
your hoverbike Drone.
• A DSm2 receiver that supports a satellite receiver is currently required for bind-
ing.
• plug the satellite receiver and the bind plug and the pixhawk into the DSm2 receiv-
er.
• Connect the hoverbike Drone via the uSb cable. the receiver should be blinking
rapidly showing that they are ready to bind.
• Caution: ensure your throttle is all the way down on your radio transmitter. whilst
holding the bind/switch button, power on your transmitter (see your radio trans-
mitter manual for details). Continue to hold the bind switch/button, the red light
on the receiver should go solid after a few seconds. the receiver light muSt go
solid for the bind process to be successful.
• you can now release the bind button on your radio transmitter.
• unplug the DSm2 receiver from the pixhawk and unplug the remote receiver from
the DSm2 receiver
• finally, plug the remote receiver into the pixhawk Spkt/DSm on the front face.
• Place the receiver somewhere safe for if you need to bind a different transmitter
to your remote/satellite receiver. Note: The channel mapping is different for the Spek-
trum Satellite receiver and will require changing in Mission Planner.
Return the throttle trim to centre.
Receiver:
Contents
System overview 4
in the box 5
Caring for Drone 6
you + Drone 7
Safety first 8
first time setup 9
batteries 12
Controls 12
warning signals 14
First flight 15
Every flight 17
flying modes 19
About Drone 20