© 2021 MA Lighting Technology GmbH - Dachdeckerstr. 16 - 97297 Waldbüttelbrunn - Germany
Phone +49 5251 688865-27 - [email protected] - www.malighting.com
1
Figure 1: Settings for the Chaser Executor
Right now the check marker on "Is Chaser" isn't filled out so it's not a chaser. Tap it once and then tap in the upper left
corner where it says Esc .
Notice that the color has changed for the executor in the Executor Bar. It now looks like this:
Figure 2: Chaser colored Executor.
Try to move the fader down and then up to 100. Now your chaser starts running.
Changing the Chaser settings
If you can't see the cue list, then press the
key again and then any of the keys associated with executor where the
chaser is running.
Now the bottom of screen 1 gives us some new chaser specific settings. They look like this:
Figure 3: Chaser options.
The top half of this gives you two different settings regarding how the different cues or chaser steps should run. Pressing
the three dots on the left opens a pop-up list with four options.
Forward
- will run the steps from the one with the lowest number to the one with the highest.
Backward
- is run from the one with the highest number to the one with the lowest.
Bounce
- will begins as a forward, then when reaching the highest number it will begin to run backwards. The result is
a constant change of direction.
Random
- is choosing a random cues/step as the next one.
The three dots on the right gives you the following settings:
Endless
- will have the chaser running until you stops it.
Shoot-Off
- will run the chaser once and then turn off. If the running order is random, then it will run the amount of
steps/cues, but not necessarily all the different cues/step!
Shoot-On
- is the same as Shoot-Off but it will pause after the final step/cue.
2 of 3
dot2 User Manual – 21 - Building chasers
Version 1.9 – 2021-05-20
English