08-04-2016
Page 3 of 6
PO Box 3785
Mooresville, NC 28117
888-438-5767
14.
Remove the factory fresh air intake hose from
the front inlet attachment. With a flathead
screwdriver, release the intake hose from the bezel in
the front of the car (near the headlight). When the
hose is disconnected, remove it from the car by
twisting it counter-clockwise out of place. You will no
longer need this hose. NOTE: It is recommended you
keep all the factory parts to reinstall at a later date if
needed.
PREPARATION FOR INSTALLATION
1.
In order to keep the wiring harness safe
from chaffing, the MAF sensor has to be
slightly rotated before the M7 AGS-R2
is installed. Cut a similar MAF sensor
notch in the hose about ¼ of an inch to
the left of the original notch. Check MAF
housing fit but
do not
reconnect to the
MAF sensor at this time.
