Compact LP VCF 116 V1b
3
Assembly Instructions
The Compact LP VCF module has no particular requirements not already covered in the
‘General Guidance on a M²Synth Module Assembly’ booklet included with this kit.
Calibration
1.
Connect a sinewave of 440Hz @ 10V p-p to Signal input 1
2.
Set Freq cut-off to 100%, Resonance to 0%
3.
Adjust PR1 to give a sinewave on the Low pass output also of 10V p-p
4.
Remove the sinewave signal from Signal input 1
5.
Increase the resonance control to 100% (self-oscillating)
6.
Measure the frequency at the Low pass output
7.
Apply a CV of 0V to the CV In socket
8.
Adjust the Freq cut-off to give 100Hz
9.
Apply a CV of 4V to the CV In socket
10.
Adjust Pr2 to give 1.6kHz
11.
Repeat steps 7-10 until calibrated
Specification
Supply v/-12Vdc
Supply current +13mA / -16mA
Waveform /-5V
Frequency range: 18Hz to 14kHz without any CV applied
Main PCB dimensions 43.5x130mm
Need tech support, post questions on our forum hosted by modwiggler.com
