5
2. Construction
Construction
The
m
2
is constructed in order to comply with the requirements for resistance and correct function in all situations. It does not limit the
skydiver in any way. It operates with minimum requirements for energy consumption, which enables it to retain a sufficient energy source
capacity for its entire service life without the necessity of battery replacement.
It is built into a harness in minimum space and allows the skydiver to open the reserve parachute primarily with the manual release handle.
Individual Device Parts
The
m
2
consists of a processing unit in which the battery is stored, a processor, an electronic circuit and a pressure sensor. The processing
unit is tightly connected via cable to the control unit, with a multi-function display and control button. The cutter is connected to the
processing unit body via a connector as a removable device part.
Never break or pull the control unit cable or the cutter cable!!!
Processing Unit
The body of the processing unit is made of aluminum alloy with a finished surface. The front face of the processing unit shows the
m
2
logo,
and on the back is the identification label. The filter is placed between the cable penetrations on the top. The whole body is sealed watertight.
On the identification label is the following information:
• SN (serial number), unique production number
• MFD (Manufacture Date), year and month of manufacture
•
m
2
AAD, commercial designation
• Made in Czech Republic and EU, country of origin
• logo and other required markings for this type of a device
2.1
2.2
2.2.1