M1-Sporttechnik Spitzing Pedelec, Руководство по эксплуатации

Страница: 13 / 20

13
To reassemble it, take care to thread the connector and cable through the seat pillar.
The connector locks into place when plugged in and the rear light, brake lights and
license plate light are active again when the system is switched on.
LOADING THE BATTERY
An charger is supplied with the electro bike. Abo-
ve the power cable connector in the charger you
will fi nd a switch which you can use to switch the
charger on and off .
During charging process with assembled battery
the display shows up “CHr6”. This is a blocker to
avoid a systems run during charging. After cut-off
of the charger the battery needs to get switched
off and on one times.
Only the original charger delivered with the
electrobike should be used to charge the battery!
Otherwise damage can occur to the system and
worst case, cause a fi re in the battery.
On the left side of the battery you will fi nd a
magnetic protective cap that covers the charger
socket. Pull this off before you plug in the charger
connector.
Simply insert in the plug in the battery. The plug
and the socket stay together, held automatically
by a magnet. Slots in the connector prevent you
connecting it with the wrong polarity (see Figure).
Take care that the plug and the socket contacts
are both dry and clean. Please also make sure
that there are no metal shavings on the contacts.
Remove them if needed.
Now you can charge the battery with power from
a regular domestic power plug (110 V AC – 240 V
AC). To do this, turn on the switch on the charger.
e-bike calssifi cation | safety notices | bike functions | guarantee statement