21
MTH E-8 Operating Manual
Feature 45. (See the section Using RESET To Program ProtoSounds® on
page 17). Once in Feature 45, press the whistle button and wait for the
module to sound a bell ding(s). Continue pressing the whistle button until
the module plays back one ding for option 1 - Squeaking brakes are
activated by the bell button. Press the whistle button again until the module
plays back two dings for option 2 - squeaking brakes are activated for full-
time operation, or press
the whistle button again
until the module plays
back three dings for
option 3 -Squeaking
brakes off. Once you
have decided on the
desired setting, simply
turn the throttle off and
then on again to “Lock-In” the new setting. To reset the computer to its
original factory default setting (option 2 - squeaking brakes are activated for
full-time operation, repeat the above procedure but keep pushing the whistle
button until the module only responds with one bell ding.
PROGRAMMING FOR HORN IN NEUTRAL
OPERATION
If you are operating your engine with a separate bell button and want to
blow your horn when your engine is in neutral, you will need to program
ProtoSounds to do so as the factory setting only allows the horn to blow in
forward or reverse. To do this, enter RESET and go to Feature 25. (See the
section Using RESET To Program ProtoSounds® on page 17.) Once in
Feature 25, press the transformer whistle button and wait for ProtoSounds
to sound a bell ding(s).
Continue pressing the whistle
button until ProtoSounds
sounds two bell dings
(signifying that ProtoSounds
has been programmed to
sound the horn in neutral).
Turn the throttle off and then
on again to “Lock-In" your
selection. Now, whenever
Clank,
Clank,
Clank,
Clank,
Clank,
Etc.
In RESET Mode
Move The Throttle
Up & Down From
High Voltage To Low
25 Times
Listen For 5 Clank
And 0 Clink Sounds
Push The Whistle Button
Until You Hear
2 Bell Dings
Interrupt The Throttle
To “Lock-In”
The Horn Setting
H
Clank,
Clank,
Clank,
Clank,
Clank,
Etc.
In RESET Mode
Move The Throttle
Up & Down From
High Voltage To Low
45 Times
Listen For 9 Clank
And 0 Clink Sounds
Push The Whistle Button
Until You Hear The
Appropriate # Of Dings
Interrupt The Throttle
To “Lock-In”
The Brake Setting
H
