M-system R7I4DML3-DAC32C, Инструкция по эксплуатации

Страница: 12 / 12

R7I4DML3-DAC32C
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
EM-8008-B P. 12 / 12
I/O DATA DESCRIPTION
■
DISCRETE INPUT MODULE
0 15
Input 0
Input 1
Input 2
Input 3
Input 15
0: OFF 1: ON
Input 7
Input 8
Output 0
Output 1
Output 2
Output 3
Output 15
Output 7
Output 8
■
DISCRETE I/O
■
STATUS
0 15
Output 0 (Overcurrent/overheat; disconnection)
Output 1 (Overcurrent/overheat; disconnection)
Output 2 (Overcurrent/overheat; disconnection)
Output 3 (Overcurrent/overheat; disconnection)
Output 7 (Overcurrent/overheat; disconnection)
Output 8 (Overcurrent/overheat; disconnection)
Output 4 (Overcurrent/overheat; disconnection)
Output 5 (Overcurrent/overheat; disconnection)
Output 6 (Overcurrent/overheat; disconnection)
Output 11 (Overcurrent/overheat; disconnection)
Output 12 (Overcurrent/overheat; disconnection)
Output 9 (Overcurrent/overheat; disconnection)
Output 10 (Overcurrent/overheat; disconnection)
Output 14 (Overcurrent/overheat; disconnection)
Output 15 (Overcurrent/overheat; disconnection)
Output 13 (Overcurrent/overheat; disconnection)
0 : Normal
1 : Detected the overcurrent/overheat and disconnection
Note: Status is disabled with option code /D1 (without wire breakdown detection).
When overcurrent or overheat is detected on each channel of discrete output while the output is ON, the status bit correspond-
ing to the output turns “1” and is latched*. Then the discrete output is also latched to OFF.
To reset the latched bit and discrete output, set this output to OFF from the host PC/PLC or turn off and on the power supply
to the unit.
When disconnection (open load) is detected while output is OFF, the corresponding status bit turns “1” but is not latched.
* The status bit turns “0” if the load is opened in the state overcurrent or overheat is detected. However, the discrete output of the
unit remains latched. Be sure to remove the cause of error and reset the latched output by setting the output to OFF or turning
off/on the power supply.