R7HL-YS2
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
EM-7812-E Rev.4 P. 2 / 5
COMPONENT IDENTIFICATION
X10
X1
STATION ADD.
CNFG.
1
2
3
4
5
6
7
8
7
8
9
10
3
4
5
2
6
1
4
5
6
7
1
2
3
TERM
ON
OFF
RUN
PWR
ON
■
FRONT VIEW
■
SIDE VIEW
Terminating Resistor SW
Status Indicator LED
Station Address Setting Rotary SW
Output Terminals
Network, Power Supply
Terminals
PC Configurator Jack
Operating Mode Setting DIP SW (SW1)
012
34
56
789AB
C
D
EF
012
34
56
789AB
C
D
EF
■
STATUS INDICATOR LED
ID
COLOR
FUNCTION
PWR
Green
Turns on when the internal 5V is sup-
plied normally.
RUN
Green
Turns on when the refresh data is re-
ceived normally.
■
STATION ADDRESS
The left switch determines the sixteenths place digit, while
the right switch does the ones place digit of the address.
The data allocation is 2.
• Full-duplex communication
Setting “n” with the rotary switches, the addresses are n
and n+2. (Range: 01H to 3DH)
• Half-duplex communication
Two (2) addresses are assigned from the one set with the
rotary switch. (Range: 01H to 3EH)
Station Address Setting (x1)
Station Address Setting (x16)
012
34
56
789AB
C
D
EF
012
34
56
789AB
C
D
EF
■
OPERATING MODE
(*) Factory setting
• Output at the loss of communication (SW1-7)
SW1-7
OUTPUT AT THE LOSS OF COMMUNICATION
OFF
Hold the output (*)
(maintains the last data received normally)
ON
Reset the output (to -15%)
• Transfer rate (SW1-8)
SW1-8
TRANSFER RATE
OFF
12 Mbps (*)
ON
6 Mbps
Note: Be sure to set unused SW1-1 through 1-6 to OFF.
■
TERMINATING RESISTOR
To use the terminating resistor, turn the switch ON, and
OFF to invalidate. (Factory setting OFF)
