![background image](http://html1.mh-extra.com/html/m-system/mib60/mib60_user-manual_3116635021.webp)
21
WHAT TO DO IN CASE OF A PROBLEM
The symbol [ E 4 ] displays :
The hob must be configured according to the following procedure.
I)
Warning : before starting all pots must be removed from the cooktop.
II)
Disconnect the cooktop from the main supply : remove fuse or disconnect circuit
breaker.
III)
Connect the cooktop to the main supply : replace the fuse or connect the circuit
breaker.
IV)
Procedure : You must provide yourself with a ferromagnetic bottom container 16 cm
minimum diametre.
* start within 2 minutes after the connection to the main supply
* do not use the [ O/I ] key.
V)
How to cancel the existing configuration :
1)
Push on key [ - ] and keep your finger on the key
2)
With a finger from the other hand : activate anti-
clockwise successively and quickly all other existing
[ + ] keys. Start with the front right cooking zone
and move anti-clockwise (a -> b -> c -> d). A double
"beep" sound will inform you of a bad manipulation
and you will have to restart from point 1.
3)
Take your fingers off the touches and re-touch and hold down [ - ] for a few
seconds, until blinking [ E ] appears.
4)
Wait until [ E ] becomes permanent.
5)
The [ E ] will be transformed automatically into [ C ]. The configuration has
been done.
Nota : Cooktops with 3 heating zones : Start the procedure with the rear right [ +
] key (b) ( the front right zone doesn't exist...)
VI)
How to configure the hob ?
1)
Use a suitable induction pot with a minimum diametre size of 16cm.
2)
Select the heating zone by pushing the corresponding [ + ] key.
3)
Put the pot on the corresponding heating zone.
4)
Wait until [ C ] converts to [ - ]. The zone is configured
5)
Use the same procedure for each other heating zone which displays [ C ]
6)
The configuration is made if all zones are detected and if nothing is displayed
Use only 1 pot to configure the hob.
Never put two or more pots on the heating zones during the configuration.
If [ E 4 ] display persists call the After-sales Service
The hob or the cooking zone doesn’t start-up :
The hob is badly connected on the electrical network.
The protection fuse cut-off
The looking function is activated
The sensitive keys are covered of grease or water.
An object is put on a key.
The symbol [ U ] displays :
There is no pan on the cooking zone.
The pan is not compatible with induction.
The bottom diameter of the pan is too small.
b
c
a
d