6
Important notice from the manufacturer
-
Before using the adapter you should carefully read the Instruction Manual and the
Technical Data. These documents including the Declaration of Conformity you will
find on the homepage
under „Produkte“.
-
An article- and series No. identifies the adapter.
-
To make sure the adapter works normally over time, the manufacturer
recommends a regular control of the sensitivity by means of a calibration by the
technician who installed the sensor.
-
The circuitry was developed following the generally recognized codes of practice,
following also E DIN EN 63027 dated February 2018. With the factory-made
settings, the circuitry works well on various PV-strings and DC-cables.
-
Caused by a variety of disturbances on DC-cables, a calibration might not be
successful for a proper operation of the adapter.
-
Before placing an order the manufacturer presumes the test of an adapter on loan
and for a certain amount of time to make sure the adapter is working properly in
the application of the customer.
-
Warranty corresponding to the General Terms and Conditions of the manufacturer.
If the customer cannot make sure that the adapter works properly in his application after
calibration, the manufacturer can help with different proposals. This would mean a change
of hard- or software, but also a statement that the adapter from M-System never will work
properly in a specific application.
Environmental notice
At the end of the product´s life, no depollution is allowed via domestic waste. The product
needs to be given to a professional collection point for recycling of electric and electronic
products.
