27
JC-IO USERS MANUAL EM-9044-B
4.4.8 P (32-bit, Pulse Transmission)
Figure 13.
Select S
Select P0 to P255.
Right-click to copy
and paste only
when the setting
values are normal.
Possible to paste
the setting values
copied by "Paste
(+1)" with the
effective register
and device number
increased by 1.
P (32-bit, pulse transmission) Setting Screen
Table 25. P (32-bit, pulse transmission) Setting Parameters
ITEM
DESCRIPTION
Mode
Enable / Disable P register.
Following parameters are configurable when Enable is selected.
CH name / CH comment
Enter the CH name and comment of P register in 32 characters or less.
Input
Connection
Select from C0 to C31.
Register
Modbus/TCP
When the protocol of the specified Connection is set to
Modbus/TCP, set the input register. When the unit identifier
is set to variable, set the unit identification number.
SLMP
When the protocol of the specified Connection is set to
SLMP, set the input device.
The display format for device address can be switched
between octal, decimal, and hexadecimal.
SWAP
Select Enable / Disable.
Modubus/TCP
Eneble: small address is lower, large address is upper
Disable: small address is upper, large address is lower
SLMP
Differs between PLC and device. Set in necessary. Refer to 3.5 SLMP
Pulse range
JC-IO accumulates the difference of pulse counter between sampling.
Set the same value as the pulse range set in the remote I/O.
Setting range is as following.
Low limit: 0 to 1,000
High limit: 10,000 to 4,294,967,295
Output
Connection
Select from C0 to C31.
Register
Modbus/TCP
When the protocol of the specified Connection is set to
Modbus/TCP, set the output register. When the unit identifier
is set to variable, set the unit identification number.
SLMP
When the protocol of the specified Connection is set to
SLMP, set the output device.
The display format for device address can be switched
between octal, decimal, and hexadecimal.