M-E Bell-556 TX, Инструкция по эксплуатации и сборке

Страница: 23 / 60

TUNING IN TO RADIO CHIME RECEIVER
The unit is delivered with a factory-set transmission code and must be
taught-in to the radio chime receiver. To do this, bring the radio chime
receiver into the learning mode (see instructions for the radio chime receiver)
and then activate the radio converter by ringing or briefly pressing the code/
melody button (4). The receiver plays a melody as confirmation.
Note: You need a bent paper clip or a biro to press the code/melody button.
Note: If your radio chime receiver activates in the meantime without reason,
it is possible that a similar device in the immediate vicinity is being operated
with the same transmission code. In this case you should change the code of
the radio converter and reset the radio chime receiver to factory settings as
described in the following paragraph and relearn it.
To change the radio converter's transmission code, press and hold the code/
melody button (4) for approx. 5 seconds. The radio converter indicates the
code change by the transmission control LED (5) lighting up for approx. 2
seconds. Afterwards a new, random transmission code is set.
For information on how to reset the radio chime receiver to the factory
setting, please refer to the instructions for the radio chime receiver. Then
carry out the programming procedure as described above.
Note: The green transmission control LED (5) lights up as soon as the Bell-556
TX transmits a radio signal.
Bell-556 TX
GB
23
GB