83
receiver or observe the display for the absence
of . If the Channel Busy Lockout feature is
programmed for the selected channel, the radio
will not transmit when the channel is busy.
3. Press and hold the PTT button. The radio will
display
and a short beep sounds (if
programmed) indicating that communication can
begin.
4. Hold the radio approximately three inches from
the mouth and speak in a normal voice into the
microphone (located at upper left front corner).
5. Release the PTT button when the transmission
is complete and listen for a reply.
The following procedures outline scan operations
for conventional channels.
ADDING CHANNELS TO A SCAN LIST
1. With scan operation turned off select the desired
channel to add to the selected conventional
system channel scan list.
2. Press
A
(Scan) or
6
(System). The
current status will be displayed in column 10 of
line three for a time-out period. Press
A
or
6
to add the channel to the scan list. is
displayed on the line. This sets the selected
channel for non-priority scanning. One of the
following messages may be momentarily
displayed:
Содержание LPE-200
Страница 1: ...Operator s Manual AE LZT 123 1868 R10A EDACS ProVoice LPE 200 Portable Radio ...
Страница 9: ...9 Figure 1 LPE 200 Radio Scan Model Shown ...
Страница 10: ...10 Figure 2 LPE 200 Radio System Model Shown ...
Страница 101: ...101 EMERGENCY NUMBERS Police State Police Fire Poison Control Ambulance Life Saving and Rescue Squad ...
