2. PC-03 controller
The PC-03 controller operates the uncapping machine and
the extruder.
The control panel is divided into two parts; the left part
controls the operation of the extruder, while the right part
controls the operation of the uncapping machine Fig.2.
After placing the device in a desired place and
blocking the wheels:
- plug in the device.
- check the level of water in the closed circuit tank
- check if the safety switch on the controller housing
is not depressed (by gently turning it as arrows on the top
of the switch) Fig3 no.4
- set the main switch to position "1" Fig 1
Power supply unit with the main switch.
230V socket Main switch
Fig.1
After the above steps, the driver panel will start.
Fig.2
400V or 230V power supply.
Check the feeder chain work direction before starting
Fig.3
1) Controller unit
2) Chain speed adjustment
4) Safety switch
3) Changing the working direction of the feeder chain
5) Knife angle adjustment
The controller unit buttons (Fig. 2) are used to switch the
machine on and off and to configure the parameters.
The settings are stored in the controller memory.
