9
USE AND CARE
CONTROLS
FAN
The fan is controlled by a multi-speed switch. Printed
speeds on the control panel correspond with fan speed.
COOKTOP LIGHTING
USE ONLY R20 SIZE, HALOGEN 50 WATT BULBS
FILTERS
Wash filters frequently either in a detergent solution, or by
placing them in your dishwasher.
Replacement filters may be purchased from Lynx.
CLEANING
Do not allow excessive grease to accumulate. Refer to Cleaning
Recommendations on last page for suggestions on cleaning
metals and finishes.
DO NOT USE ABRASIVE CLOTH, STEEL WOOL PADS,
OR SCOURING POWDERS.
Vacuum fan to eliminate collected dust and particles.
Do not immerse fan in water.
REPLACEMENT PARTS
For purchasing replacement parts, contact Lynx.
1. Grease trough location is on the underside (bottom), rear
area of hood.
2. In the center of the space provided for the filters, insert one
filter on the top ledge and pull back until the bottom of
the filter slips into bottom ledge.
3. Slide the filter to one side.
4. Install the next filter by repeating step 2. There will be some
side-to-side and front-to-back tension as the filters line up.
5. Install halogen bulbs. Use R20 size, 50 watt maximum,
narrow flood light bulbs only (purchased separately).
INSTALLATION OF GREASE TROUGHS, FILTERS, LAMPS
Hood Assembly
Baffle or Mesh
filter
grease trough
Always turn the hood on before cooking to establish an air
flow. Allow the fan to operate for a few minutes to clear
the air after you turn the grill off. This will help keep the
area smoke free and fresher smelling.
The halogen lights are controlled with two (ambient and
brilliant) rotary switches. The lights can be turned on
individually or simultaneously. To use the lights on
brilliant setting, rotate switches clockwise. For ambient
setting, rotate switches counter clockwise.
