Lynx
Model
No.
LHFS
Page
4
P/N
33348
Rev.
A
7/2010
Caution and General Safety
•
NEVER paint the Burner, Emitter, Shield Support Arms or the Reflector.
•
The visible portion of the Hose Assembly must be visually inspected before each use. If
there is evidence of excessive abrasion or wear, or if the hose is damaged the hose
assembly must be replaced prior to the appliance being put into operation.
•
This appliance shall be used only in a well-ventilated area/space and shell not be used in a
building, garages or any other enclosed area.
•
Never go over connections looking for leaks with a lighted match, cigarette lighter, or any
other flame.
•
Perform the Leak Test before initial lighting and when connecting a new LP-Gas Cylinder.
A complete gas tightness check must be performed at the installation on site due to possible
miss handing in shipment or excessive pressure being applied to the heater.
•
Turn OFF LP-Gas Cylinder when Heater is not in use.
•
Once the Heater has been shut-down there shall be a 5-minute complete shutoff
period before the Heater is re-lighted.
•
Ensure the LP-Gas Cylinder is turned OFF and disconnected prior to moving the Heater.
•
Storage of a Heater indoors is permissible only if the LP-Gas Cylinder is disconnected and
removed from the Heater.
•
Use caution when moving the Heater, it may require two people to safely manoeuvre
depending on the strength / size of the person(s). Handle ONLY the Pole or Base Body
when moving the Heater, handling other components may result in damage and/or injury.
LP-Gas Cylinder Caution and Safety
•
Do not store a spare LP gas cylinder under or near this appliance.
•
Never fill the Cylinder beyond 80 percent full.
•
Keep Cylinders upright at all times, even during storage and transport.
•
The pressure regulator and hose assembly
supplied
with the Heater must be used, or the
replacement Hose Assembly
shall be
that specified by the manufacturer.
•
LP-Gas Cylinders must be stored outdoors in a well-ventilated area out of the reach of
children. A disconnected cylinder must have dust caps tightly installed and must not be
stored in a building, garage or any other enclosed area. Ensure the storage area meets all
local fire & safety requirements.
