Lynx L24FR-2, Инструкция по уходу, использованию и установке

Страница: 33 / 48

33
GAS CONNECTIONS
the grill is factory set to use
either propane (lp) or natural
gas (nat). it is critical that the
gas you use matches that
which the grill was set up for.
you can verify that by
checking the
rating plate
.
the rating plate is located in
one or more of the following
places:
►
attached to the underside
of the drip tray
►
on the heat shield behind
the front panel
the Rating plate lists serial numbers,
model numbers and gas type. this
one is underneath the drip tray.
ensure that the gas supplied
meets with the minimum
pressure requirements. Do not
operate the grill on any gas
other than that for which the
grill has been set.
fuel wc
max
inlet
wc min
under
full load
nat gas 7 in 4 in
lp 14 in 11 in
Water Column Requirements
Both the regulator and the
manifold orifices have been
tuned for the type of gas
specified on the rating plate.
converting to a different type
of gas requires a conversion
kit, available from lynx or
from your dealer and must be
installed by a qualified techni-
cian.
all installation and all instal-
lation parts must conform to
local codes with the national
electrical code, ansi Z223.1/
nfpa 70 latest edition and
the national fuel gas code,
ansi Z223.1/nfpa 54 in the
u.s and cga-B149.1/.2 in
canada.
canadian installations must
conform to cga-B149.1/.2
natural gas/propane installa-
tion code. (canada)
natural gas
lynx recommends that
only qualified profession-
als perform the required
plumbing on this product.
to ensure satisfactory per-
formance, the gas supply
line must be sized to ac-
commodate the total Btu
requirements of all the gas-
fired equipment that will be
connected to that line.
in no case should pipe less
than 3/4” inside diameter or
1” outside diameter ever be
used to connect this product.
►
calculate the total Btu
output of all equipment
and refer to “indeX: gas
supply line Runs” for
allowable run distances
for ¾ inch pipe. failure
to meet these minimum
requirements may reduce
performance of the grill
and any other appliances
running on that supply line.
►
always keep supply line
runs as short as possible.
(see indeX: “Btu output” for
specific model ouputs)
►
a gas shut-off valve must
be installed in an easily
accessible location by a
qualified plumber.
warning
Never coNNect a gas liNe directly to the grill. a pressure regulator must be
iNstalled oN all gas equipmeNt. all local codes require it aNd lyNx supplies the
correct regulator with your grill. removiNg or failiNg to iNstall the pressure
regulator caN result iN fire aNd serious persoNal iNjury aNd will void the
warraNty.