12
OPERATION
The Lynx L24BF comes equipped with a state of
the art refrigeration system. The compressor is
of a variable speed variety, which automatically
changes speeds based on system conditions
and load. The cabinet is equipped with an
adjustable digital temperature controller and
LED display.
The refrigerator is a frost-free model meaning
the evaporator (cooling coil) automatically
defrosts on demand at predetermined intervals.
The controller also has a manual defrost soft
button on the front panel signified by a melting
snowflake. If depressed it will automatically put
the system into a defrost cycle.
Interior light
The unit is equipped with an interior light that is
illuminated when the door is opened. The
cabinet also comes standard with a manual light
switch located next to the light. Always ensure
that the manual switch is in the off position
before closing the door. If manual light switch is
left on for an extended period of time it may
increase the cabinet temperature, especially at
the top and cause the refrigeration system to run
longer.
Loading Product
IMPORTANT NOTE:
Before storing perishables,
allow unit to run for a minimum of 24 hours to
allow temperature stabilization after start-up.
When loading items into unit, do not block
internal louvers and fan guard openings or
performance will be decreased.
Temperature Control Panel
The controller is located inside of the unit. The
display will read OFF when unit off and will show
temperature when unit is on.
IMPORTANT NOTE:
the led display is reading
actual air temperature not
product temperature.
Under these conditions, an air temperature
swing does not change the actual product
temperature. Product temperature remains at a
very stable temperature, within a 6
°
swing.
Step 12
Step 13
11
7. Remove the Lynx name plate from
the Door using a Plastic Putty Knife.
Install the new Lynx nameplate
(included)
8. Insert bearing into Top Door Hnge
Bracket
9. Insert V-Block into Bottom Door
Hinge Bracket, attach with E-Clip
10. Attach the Top and Bottom Door
Hinge and Push Plunger using screw
removed in Step 6
11. Place Lower V-Block into Lower
Cabinet Hinge with notch parallel to
cabinet
12. Lift the Door Assembly and insert
top pin into bearing. Then move door
toward cabinet and align V-Blocks
13. Insert and tighten the Lower Hinge
Pin to complete assembly
Step 8:
Step 9:
Step 10:
Step 11
