Reference Manual D VD 5002 Version1.1
Page 13
Switch Settings
Below the switch settings for the 6-position dip-
switch are defined.
*When in single mode the
IN 1
video input is used.
**When in single mode Switch 3 is active, switch 4 is
deactivated.
Switch Function Detail
Dip Switch 1
This switch is used to enable or disable local
adjustments. Set to
ON
enables the setting of the
other dip switches to configure the module. Set to
OFF
will prevent any switch settings taking effect.
Note.
The module has a microcontroller and flash ram. When this
switch 1 is set to
ON
any configuration settings made on the
module with the dip switches will automatically be written into
flash ram and stored. (see Auto Store) The module will function
normally with the switch left in the
ON
position but it is
recommended to set it to
OFF
to prevent accidental changes to
the stored module configuration if the switches are moved.
Dip Switch 2
When set to
ON
this configures the module for dual
1:2 mode of operation,
OFF
sets single 1:4 mode.
Note
when in 1:4 mode
IN 1
is used for the single input channel.
Switch
Setting
Function
ON
Enable Local Adjustment
1
OFF Disable
Local
Adjustment
ON
Dual 1:2 mode
2
OFF
Single 1:4 mode *
ON
Outputs 1 to 2 Reclocked **
3
OFF
Outputs 1 to 2 Non-reclocked **
ON
Outputs 3 to 4 Reclocked **
4
OFF
Outputs 3 to 3 Non-reclocked **
ON
Analog Output 1 from SDI IN 1
5
OFF
Analog Output 1 from SDI IN 2
ON
Analog Output 2 from SDI IN 2
6
OFF
Analog Output 2 from SDI IN 1
