Reference Manual C DA 5010 Version1.8
Page 14
Switch Settings
Below the switch settings for the 8-position dip-
switch are defined. Please see the section following
the table for more detail on the switch function.
Switch Function Detail
All settings are stored in Flash Ram inside the
module (see Auto Store section in this manual).
Settings will be recalled on power up.
Dip Switch 1
This switch enables local control using the dip-
switches.
ON
enables local control and makes
selections on the dipswitch active, and
OFF
disables local control (locking out any local
changes)
Note.
When Switch 1 is initially switched to
ON
, the static
settings currently set on the dip-switches may not
reflect the actual configuration stored in the
module. This is because all settings can be
Switch
Setting
Function
ON Enable
Local
Adjustments
1
OFF
Disable local Adjustments
ON
RGB Component Output
2
OFF
YUV Component Output
ON
3 x CVBS outputs
3
OFF
1 x CVBS and S Video (Y/C) outputs
ON
Test signal (color bars) ON
4
OFF
Test Signal (color bars) OFF
ON
Test Signal format = NTSC
5
OFF
Test Signal Format = PAL
ON
Switch 7 active
6
OFF
If no input, then output = Color Bars
ON
If no input, output disabled
7
OFF
If no input, then output = Color Bars
ON
VBI disabled (transparent)
8
OFF
VBI enabled (blanked)
