2
setting of working hours
)
for example:
7)
When the menu “Roast” is selected, icon is ON. The temperature display column
will show “F-1”, and meanwhile, the time display column will show the required working
time. Press the selection key “ ”, the temperature display column will show “F-1”,
“F-2”, “F-3” … “F-9”.. “F-1”, and repeat this circle, and the corresponding time column will
show the required time. Press the ENTER key, the machine begins to work and the time
begins to count down.
3)
Setting of working hours and temperature, top heater pipe icon “ ” will flash.
4.Start work
Attention:
all functions shall be adjusted according to this adjustmen
order except for the fixed time and temperature.
Note:
water tank icon will be displayed when a steam-related function is
selected (such as, steam, high-temperature steam, ferment, unfreeze etc.),
5.During the work
1)
During the working process, the machine will pause the work if the ENTER key is
pressed, the working time will stop the countdown, the display interface will stay in the
working state interface, and the time bit number will keep its original data to flash and
beat, which indicates that the machine is in a working status of pause. Press the ENTER
key again, the machine is started to continue the work until the cooking is completed.
2)
Add the time and adjust the temperature in the midway
During the cooking/Beaking / Roasting process, if you want to adjust the cooking time
operation is as follows:
or temperature, the
1 Press Setting key “ ” until the “Time-delay” icon “ ” on the screen is ON. At
the minute bit will flash. The minute bit can be adjusted by pressing the
this time,
selection key “ ” “ ”(setting of hour bit is not available for delay time function).
2 After the minute bit is adjusted, press the ENTER key to enter the setting of temperature.
If you do not need to adjust the temperature, please press the ENTER key to directly start
the work;
Pause
-9-
8)
When the menu “Bake” is selected, icon is ON. The temperature display column
will show “H-1”, and meanwhile, the time display column will show the required working
time. Press the selection key “ ”, the temperature display column will show “H-1”,
“H-2”, “H-3” … “H-9”.. “H-1”, and repeat this circle, and the corresponding time column
will show the required time. Press the ENTER key, the machine begins to work and the
time begins to count down.
9)
When the menu is selected, the “steam” function icon in upper left corner is ON.
Press the selection key “ ”to enter the function selection mode. The display column at
the left side of the screen will show the corresponding function icon, as shown in the
following figure. There are 9 DIY regular function modes.
Each gear of the key corresponds to a function. The key moves a gear, the function icon
will automatically jump down to flash, and the frame will not flash. After the desired
function is selected, it can be confirmed by press the ENTER key
10
When the menu “Descaling” is selected, the icon is ON to remove the scale.
(Working time of 50 minutes is not adjustable. The work process cannot be paused)
3. Setting of working hours and temperature
After the desired function is selected, it shall be confirmed by pressing the ENTER key
to enter the setting of working hours. The hour bit will flash. Press the selection key
to set the hour bit. After it is confirmed by pressing the ENTER key, the minute bit will
flash, and then press the selection key to set the minute bit. After it is confirmed by
pressing the ENTER key, the temperature bit will flash, and then press the selection
key to set the working temperature for “Top heater pipe” and “Bottom heater pipe”.
finished, press the ENTER key to start working.
After the setting of working temperature is
For example, the setting of “Top heater pipe” working mode:
1)
Select function
)
-8-
DIY
°F
F
F
°F
F
°F
F
°F
F
°F
F
°F
F
