INSTALLATION OSLO IR
The apparatus must be installed on a vertical wall using the wall mounts supplied.
Suitable screws and plugs are included.
The apparatus’ mounting components are adjustable vertically, horizontally
and as regards depth (see exploded diagram in the box), which makes correct
installation easier. Positioning can be seen from the figure on the drawing page.
Start by screwing the two upper wall mounts securely into the wall. (The distance
between the mounts can be seen from the figure on the drawing page.) Ensure
that the mounts are horizontal. Install two clamps between the highest and
second-highest horizontal tubes.
Screw in the outer clamp so that the holder is loosely clamped between the
tubes.
Install the clamps between the lowest and second-lowest tubes. Screw in the
outer clamp and provisionally install it on the loose wall mounts.
Hang up the apparatus by inserting the upper holder pins in the upper wall
mounts.
Check that the apparatus is vertical and centred.
If necessary adjust by moving the towel drier sideways or by adjusting the wall
mounts, which are also adjustable.
Temporarily tighten the upper mounts in order to mark the location of the lower
wall mounts on the wall.
Remove the apparatus again and screw the lower wall mounts securely into the
wall (according to the wall markings).
Hang the apparatus in all the holder pins and finally tighten all the screws.
The apparatus can also be adjusted as regards depth. Also tighten the screws.
Check that the apparatus is hanging correctly, otherwise readjust.
Press the cover plates into position on the front to hide the screws.
INSTALLATION PARIS IR
The apparatus must be installed on a vertical wall using the wall mounts supplied.
Suitable screws and plugs are included.
The apparatus’ mounting components are adjustable vertically, horizontally
and as regards depth (see exploded diagram in the box), which makes correct
installation easier. Positioning can be seen from the figure on the drawing page.
Start by marking out the four holes on the wall.
Screw the two upper wall mounts securely into the wall. (The distance between
the mounts can be seen from the figure on the drawing page.) Ensure that the
mounts are horizontal.
Insert the upper holder pins in the upper wall mounts, then hang the apparatus.
Check that the apparatus is vertical, otherwise adjust the wall mounts.
Temporarily tighten the upper mounts in order to check the markings on the wall
for the location of the lower wall mounts. If necessary adjust the markings.
Remove the apparatus again and screw the lower wall mounts securely into the
wall (according to the wall markings).
Hang the apparatus in all the holder pins and adjust the depth, if necessary. Finally
tighten the screws.
Check that the apparatus is hanging correctly, otherwise readjust.
Pull out the cover cylinders towards the apparatus in order to hide the holder
pins and secure the apparatus. Then tighten the screws.
