User Guide
20
© Copyright 2011 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
Administrator Login:
Sets the password for Administrator access to the
XenSmart™ web management interface. When connecting to the Access Point
through the XenSmart™ web interface, the user is prompted for a User ID (this is
always admin) and Password (the default value is “admin”). It is HIGHLY recom-
mended to change to a secure password when initially confi guring the Access
Point. To change the password, simply enter the new password, confi rm the
password, then click
Save
, and then
Reboot
for the change to take effect.
After confi rming the desired Quick Setup confi guration settings, select
Save
and
then
Reboot
for the settings to take effect.
5.3 Wireless
5.3.1 Basic Wireless Settings
Basic Wireless Settings:
This screen allows the modifi cation of the following basic
settings for the wireless network:
Wireless Radio:
This fi eld is used to Enable and Disable the wireless network and is
set to Enabled by default. If the Radio is Disabled the Access Point will not broadcast
a wireless signal. To Disable the Wireless Radio, click the dropdown menu, select
Disabled
, then click
Save
and then
Reboot
for the change to take effect.
Channel:
This fi eld allows the user to set which 2.4GHz channel to use. The
default is set to Channel 6 and is the recommended setting due to the Access
Point being optimized to run on Channel 6. However, any other channel (1-11) may
be selected. To change the Channel, click the dropdown menu, select the desired
channel, then click
Save
and then
Reboot
for the change to take effect.
Wireless Mode:
Sets the type of 802.11 wireless network to be broadcast.
Available modes are:
11g (802.11g)
11gnHT20 (802.11g/n with 20MHz only channels)
