Pro-WAV™ 200 Lite QUiCK instALL GUiDe
Connecting the EnGenius ECB3500 to the Antennas
(diagram 2)
1. Remove the stock antennas from
the antenna ports of the EnGenius
ECB3500 and set them aside.
2. Connect the RP-TNC connector
of the coax cable to the primary
antenna port
1
.
3. Connect the N-Male connector of the coax cable to the splitter.
PoWeriNg yoUr Pro-WAV 200 LiTe sysTem
For maximum fl exibility you may power the Wi-Fi Range Extender System by Direct Power
or POE using the included Luxul Wireless POE Injector, an IEEE 802.3af compliant POE
injector or POE enabled switch, (Check the POE injector or switch manual for instructions).
Setting up Power Over Ethernet (POE)
(diagram 3)
1. Install the Luxul POE injector or your injector where
you have access to your data source/network
Ethernet cable and a power source.
2. Connect your Ethernet cable from your data source/
network to the “Data In” port of the Injector.
3. Be sure the power supply is not connect to a
power source. Connect the power supply cord to
the “DC In” port of the injector.
4. Connect the Ethernet cable from the “DC/Data Out”
port of the injector to the pass through port on the outside of the Pro-WAV Lite.
POE Injector
Ethernet
Source
Ethernet to
Pro-WAV
48VDC
Power Supply
DC
In
DC/Data
Out
Data
In
diagram 3
EXT ANT
EXT ANT
DC IN
RESET
RJ45/POE
PRIMARY
ANTENNA
PORT
1
diagram 2
PosiTioNiNg yoUr Pro-WAV 200 LiTe sysTem
The Pro-WAV 200 Lite System features high gain directional antennas. Remember to con-
sider the direction of the signal when positioning the Pro-WAV 200 Lite System. The signal
extends out in both directions from the antennas mounted on the sides of the enclosure. If
mounting the Pro-WAV 200 Lite high in your Wi-Fi coverage area the antenna mount may
be bent slightly downward to focus coverage. Use diagram 7 below to position your Pro-
WAV 200 Lite system for maximum Wi-Fi coverage.
diagram 7
